The hole under the big light. We clipped the ends of the wires and shoved them above the ceiling.

We pulled the patch over the table to see where some of the wires ran using mirrors and flashlights.

Mike measures the hole for the main entry junction box over the sink. At the top of the picture is the register opening, We had to cut part of the sheet metal to get at the wires.

Mike

This shows the hole in the register opening. Mike is getting material to fix it the next trip.

Looking inside the register opening at the sink light wire.

Trench with the repair job and a piece of the old rusty pipe. I think this is where the tick got on me. I was down on hands and knees digging dirt from around the buried pipe.

Mike fills in the hole

Mike covers the pipe repair job

Terri watches Mike shovel the dirt

This is the cable and the rusted pipe ends we cut off to repair the underground feed.